Stencil Remover is available in two forms - (A) White Crystalline Powder and (B) Aqueous liquid concentrate.

Its use is to remove the stencil from the mesh during the frame reclaiming process. The instructions for use are as follows.....

(A) Product as a powder. Dissolve the entire contents in 25 litres of warm tap water.

(B) Aqueous liquid concentrate. Dilute with cold tap water to a volume of 25 litres.

The product can be used at this concentration but further dilution with water is possible. The extent of this further dilution will depend on how easily the stencil material can be removed. (Water resistant stencils usually require the product to be used at the higher concentration).

The application method is normally by brush over the whole stencil area. The stencil remover should be allowed to soften the stencil before washing the mesh with high pressure water jet. The time required to soften the stencil will depend on the concentration being used and the water resistance of the stencil material.